Cold & Heat 4 Tanks Juice Dispenser
Product Description
Good quality Cold & heat double tank juice dispenser
| Model | LRYJ10LX4 |
| Voltage | 110V-130V/220V-240V |
| Frequency | 50HZ/60HZ |
| Heating Power | 1000W |
| Cooling Power | 300W |
| Temperature Range | 7 -12ºC( Cool ) 52-58ºC (Heat) |
| Bowls Capacity | 10L×4 |
| N.W. | 39kgs |
| G.W | 43kgs |
| Dimension | 445*590*680mm |
Features:
1,Single cold or both cold and heat model for your choose.
2:,High quality compressor,
3,Automatic control,
4,Super strong and nonpoisonous tank,
5,Acid, alkali and low temperature resistant,
6,High capacity with low power,
7,Lower noise, High efficiency pump.
Installing method for reference:
1: To install it ,pls choose the site which is flat, fixable and can avoid the direct sunshine in summer.
2:Around the juicer, should have 150mm up room to make the air circulating and make sure the machine can run effectively
3:Before installing, pls check the supply whether confirm the requirements or not. The power supply cable is not too thin or too long. The cross section of cable should be 1.5-2.5mm, Voltage is mounted on the fixed position with fuse which will keep the users safety,it must have reriable grounding. The socket should be mounted on the fixed position with fuse which keep the machine running safety.
4;To make the fix position for juicer,should make its frond lower and back higher(to ajust the foot of bottom can do it), then the water in the salver can flow into the box through the hose.
More models for you choose:
1,Single cold or both cold and heat model for your choose.
2:,High quality compressor,
3,Automatic control,
4,Super strong and nonpoisonous tank,
5,Acid, alkali and low temperature resistant,
6,High capacity with low power,
7,Lower noise, High efficiency pump.
Installing method for reference:
1: To install it ,pls choose the site which is flat, fixable and can avoid the direct sunshine in summer.
2:Around the juicer, should have 150mm up room to make the air circulating and make sure the machine can run effectively
3:Before installing, pls check the supply whether confirm the requirements or not. The power supply cable is not too thin or too long. The cross section of cable should be 1.5-2.5mm, Voltage is mounted on the fixed position with fuse which will keep the users safety,it must have reriable grounding. The socket should be mounted on the fixed position with fuse which keep the machine running safety.
4;To make the fix position for juicer,should make its frond lower and back higher(to ajust the foot of bottom can do it), then the water in the salver can flow into the box through the hose.
More models for you choose: